Protocol/TETRA 썸네일형 리스트형 14.5.4 SS procedures Figure 14.23 shows the internal architecture of the SS sub-entity. The user application shall communicate with SS entities via the rb-route, when the information of the requested service is not incorporated into TNCC-SAP service primitives, see clauses 11 and 12. [code] 그림을 보면 SS 보조 엔티티의 내부 아키텍쳐를 볼수 있다. 사용자 요청으로 SS 엔티티들과 rb-route 를 통해 대화해야할 것이다. 요청한 서비스의 정보는 TNCC-SAP service primitive 들내에 조직되어 있.. 더보기 14.5.3.2 MS related procedures 14.5.3.2 MS related procedures 14.5.3.2.1 General procedures The MAC layer manages radio channel changes as described in clause 23.5.4. It is possible that the MAC layer may receive conflicting channel allocations when the MS is already involved in a service and receives a new service indication. Also, the SwMI may re-allocate radio resources so that concurrent services a MS is using are no long.. 더보기 14.5.3 Traffic channel assignment procedures 14.5.3 Traffic channel assignment procedures 14.5.3.1 SwMI related procedures This clause describes procedures which shall be applicable only to the SwMI. Depending on the traffic case, alternative methods for traffic channel assignment can be used as presented in table 14.1. [code] 이 장은 SwMI에만 적용할 수 있는 절차를 묘사하고 있다. 트레픽 케이스를 의존한다. 트레픽 채널 요구를 대신할 것을 지금 선택할 수 있다. [/code] For the called MSs in a gr.. 더보기 14.5.2.7 Call ownership 14.5.2.7 Call ownership The CC states and state transitions described in this clause are defined in clause 14.4.2. [code] CC 상태 그리고 이장 내에 선언되어 묘사된 변화 상태 [/code] Upon entry to the MO-CALL-SETUP state from the IDLE state, the MS shall assume it is a call owner. [code] IDLE 상태에 MO-CALL-SETUP 를 하기 위한 entry MS는 콜이 소유자라고 가정할 것이다. [/code] Upon entry to the MT-CALL-SETUP state from the IDLE state, the M.. 더보기 14.5.2.6 Acknowledged group call procedures 14.5.2.6 Acknowledged group call procedures The MS procedures for handling of an acknowledged group call shall be in accordance with the procedures described for a normal group call in clauses 14.5.2.1 to 14.5.2.4 with the following additions, which for the SwMI side are informative. [code] MS는 그룹 콜이 적합하다라고 수신 여부를 다루는 것을 위한 절차이다. 절차는 기본적인 그룹 콜을 묘사하고 있다. 다음에 추가되어 SwMI 사이드 에 정보가 많다. [/code] The Sw.. 더보기 14.5.2.4 U-Plane switching 14.5.2.4 U-Plane switching [code][/code] The U-Plane switching procedure ensures that traffic/signalling synchronization between the CMCE and the MAC shall be maintained during the lifetime of a call. The CC informs the MAC when it has permission to transmit traffic (i.e. TCH or STCH) and when to stop. [code] U-Plane 스위칭 절차를 확실히 한다 그것은 트래픽/시그널링 신호를 CMCE 에서 MAC 간에 콜이 진행하는 동안을 유지하며 맞춘다. [/code] Th.. 더보기 14.5.2.3 Call disconnection procedures 14.5.2.3.1 User initiated disconnection A user application may initiate call disconnection at any state of a call by sending a TNCC-RELEASE request primitive to the CC sub-entity. [code] TNCC-RELEASE request primitive 에서 CC 보조 엔티티로 전송하는것에 의해서 콜에 어느 상태가 call disconnect 상태가 될 수도 있다. [/code] A call owner shall signal call disconnection to the SwMI by sending a U-DISCONNECT PDU. [code] call 에 소유권은 c.. 더보기 14.5.2 Group CC procedures 14.5.2 Group CC procedures The CC procedures handled by CC shall be applicable for circuit mode calls for both speech and data. [code]CC 말하고 데이터를 양쪽무데에게 서킷모드콜들에을 지원하는 것에 의해서 CC 의 절차를 다룰 것이다.[/code] The circuit mode speech and data group calls shall be set-up as point-to-multipoint calls. [code]서킷모드로 말하고 데이터 그룹콜을 P-TO-M CALL ㅇ서 설정할 때[/code] The specification below shall be applicable for the proc.. 더보기 14.5.1.3 Call disconnection procedures 14.5.1.3.1 User initiated disconnection Either the calling or called user application may initiate a call disconnection at any state of a call. This shall be done by sending a TNCC-RELEASE request primitive to the CC sub-entity. [code] calling 혹은 called 어느 한쪽에사용자 요청으로 call 의 어느 상태에 call disconnection 초기화 되어 TNCC-RELEASE request primitive 를 CC sub-entity 로 sending 해서 down 될것이다. [/code] • During c.. 더보기 Figure 14.14: Individual call - unsuccessful call restoration 더보기 이전 1 ··· 4 5 6 7 8 9 10 ··· 12 다음
